Access & Attendance CCTV Surveillance Fire Alarm Security Alarm Solutions Connectivity Solutions PA Systems

Office Network
Worlds the best IP[Network] CCTV
Member Login


Forgot Password..?

Intelligent Fire Accessories
Fire Alarm
Horn cum Strobe
Horn/Strobe provides a wide range of candela light output options in a single device. The candela settings include a 12 or 24 volt DC operation for the 15, 35 and 60 (75 on axis) candela settings and 24 volt DC operation for the 15, 35, 60, 75, 95 and 110 candela settings. The candela setting is displayed through the front window and is selectable using a drum wheel. The strobes can be synchronized using a control panel with the Mircom (Amseco) sync protocol or an SDM-240 sync module.
Intelligent Manual Stations
Single or Dual Action Key resettable
Permanently attached Intelligent Addressable
High-gloss red enamel finish
Plastic breakrod
Meets ADA 5 lb. maximum manual-force
Mounts on standard single gang box, Secutron's
surface metal backbox or MRM-700WP
weather proof backbox
Isolator Module
Isolator Module is an automatic switch
that opens when the line voltage drops below four volts. Isolator modules should be spaced between groups of sensors or modules in a loop to protect the rest of the loop. If a short occurs between any two isolators, then both isolators immediately switch to an open circuit state and isolate the devices between them. The remaining units on the loop continue to fully operate. No more than 25 devices are recommended for each group.
Remote Power Supply
Mircom's BPS-602 is an extremely cost effective 6.5 amp voltage regulated remote power supply/battery charger. It may be connected to any 12 or 24 volt Fire Alarm Control Panel (FACP). Primary applications include Notification Appliance Circuit (NAC such as strobes and horns) expansion support to meet ADA requirements. It also provides auxiliary power to support system accessories. The unit delivers regulated and filtered 24 or 12 volt power to Class B or Class A NAC loop circuits.